How to Place and Connect Nodes
- Click Nodes tab to see all the available nodes.
- Click Start node and drop the node on canvas area.
- Select a node and drop this on canvas area. Place all the other required nodes similarly.
- Select End node and drop this on canvas area.
Note: A process should always begin with a Start node and then add the other required nodes ending it with the End node.
To connect two nodes:
Forward Connector node is used to represent the data flow from one node to the other. So the source node for a forward connector should always be either an R2O node or a Middleware node.
- Click on the Forward Connector node.
- Click and drag the mouse from the source node onto the target node and release it.